Specifications include, but are not limited to: 15.1 ITEM 1 HAND SINK Four required Fabricated Four stainless steel wall-mounted hand sinks, 16 ga. S/S, each with 14" x 12" x 8" deep bowl with integral side splashes, Z-bracket, S/S three-sided apron and the following accessories: 20 A. T&S Model EC3101 splash-mounted hands free faucet with gooseneck swivel spout and aerator. Provide a single hole in the backsplash for the faucet mounting. Include #013141-45 solenoid valve, #013130-45 mixing valve, control module and two #013146-45 braided hoses. B. Chrome P-trap. C. 1 1/2" S/S basket strainer. 15.2 ITEM 2 STAINLESS STEEL WALL COVERING Lot required Fabricate Provide 18 ga. #4 finish S/S panels below the hood, Item 3, along the full length of the hood. The paneling shall extend from the top of the flooring base material to the bottom edge of the hood. Joints between the panels shall be covered with Component Hardware Model J64-1450 H strips. Edges shall be capped with Component Hardware S/S continuous U-clips. Seal the panels with clear silicone. All panels shall be securely attached with a generous amount of clear silicone on the full perimeter of each panel (blind caulking) and on the rear surfaces in order to achieve a tight, flat, bonding of the panels to the walls. Make close-fitting cut-outs for all utilities.