Specifications include, but are not limited to: A. BODY Henderson Mark II or Crysteel Select -10’ Stainless Steel Dump Body with Hoist, single horizontal brace, western style understructure, box construction to be a min. of 7ga. 201stainless steel, ¼” AR400 floor, two panel double acting 7ga. 201 stainless steel tailgate with 1-1/4” pins. 6 yd. capacity. Step to be welded on the front drivers side corner of box and grab handle welded on front drivers side corner of cab protector. Grease fittings on tailgate linkage and locking lobs. Bustin safety bar full length of box with grab handles. Body left in bare stainless steel.; 1. Cab protector: 23” tapered mounted so as not to interfere with vertical exhaust pipe.; 2. Box raise indicator light in cab; 3. Box vibrator- use factory installed switch in chassis; B. LIGHTS Electrical wiring suitably protected from rubbing against other parts of the vehicle. All exterior connections to be waterproof. All lights are to be separately fused. Lights cannot be hooked up through the ignition switch. Directional and plow lights are to be mounted so as to be visible when plow is in raised position. ; 1. (6) Ecco 3965a oval amber LED strobe lights (4) on cab protector with stainless steel encloser 2-facing the front and 2-facing the rear, (2) recessed in the rear corner posts.; 2. (2) Ecco 9014a Cat Eye amber strobe lights mounted on the cab protector –1- mounted on the left side and 1-mounted on the right side; 3. LED body and parking lights. ; C. HOIST Henderson UB8-17CDA-LH, or Crysteel RC750- Double Acting Underbody Hoist class 50 – 17.5 ton capacity.; D. SPREADER Swenson direct drive single auger #SBD-9-S, or Monroe MS969 with spinner, Stainless Steel Spreader (9”auger) – include custom made stainless steel corner plates fastened to the sides of the auger unit to prevent material spillage from sides of auger, and removable heavy duty stainless steel tailgate shields mounted on the inside of the tailgate. ; E. SNOWPLOW Wausau Model RB4211, 11’ with loop style set-up. (Schmidt 225C low Pro hitch) or Monroe MP41R11-isct with loop style set up: QCP lo profile Hitch. Jack kit to include a removable top wind tube jack stand
