Specifications include, but are not limited to: 3.1.1.1 Units must be completely new. 3.1.1.1.1 Used, remanufactured, refurbished, demonstration units, dealer samples or any other condition other than new is not acceptable. 3.1.1.2 Units must be designed to sit directly on the floor. 3.1.1.2.1 Units must sit flush on floor without legs. 3.1.1.3 Units must not measure any greater than 20” deep x 20” wide x 60” height. 3.1.1.4 Units must operate on a GFI (Ground Fault Interrupter) outlets and have a maximum full load draw of no greater than 10 amps. 3.1.1.5 Units must have a minimum of 5-step filtration. 3.1.1.5.1 Multiple Stage purification through filters that removes (1) sediments filter, (1) pre-carbon filter, (2) Dual reverse osmosis membrane filters, and (1) Polishing filter for better taste. 3.1.1.6 Units must have stainless steel water holding tanks with a minimum usable capacity of 1 gallon. 3.1.1.7 Units must have an internal shut off for hot water. 3.1.1.7.1 Units must include a leak detection feature with the automatic water shut-off. 3.1.1.7.2 Units must have safety button for hot water dispensing to prevent accidental burn or dispensing. 3.1.1.8 Units must have an anti-microbial display panel. 3.1.1.9 Units shall have cup holder attached to allow for convenience of use. 3.1.1.10 Units must have reverse osmosis purification. 3.1.1.11 Units must have notification lights that alert when unit is in need of service and/or filter replacement. 3.1.1.12 Units must produce a minimum of 30 lbs ice daily. 3.1.1.13 Units must store a minimum of 8 lbs of ice ready for use.