Specifications include, but are not limited to: Materials Hangtags will be manufactured on a Triplex material. The hangtags shall consist of three (3) layers. The center layer shall be a single layer, highly filled micro porous, plastic film. The center layer must not delaminate under the demand of normal hangtag applications. The center layer shall be sandwiched between two polyester outer layers with an aggressive adhesive. These permits are needed for various areas and numbering. Material colors will vary based on client needs but may include yellow with black text, green with white text, blue with white text, orange with white text, and red with white text. Print on both sides. Weathering Qualities The permits must be guaranteed to perform satisfactorily in the heat and not to break in the cold and withstand the general intended use with daily handling and transferring. All printing and numbering on permits shall do done using sun resistant inks that will remain in good legible condition for a period of one (1) year after permit has been in use on vehicle and should exhibit minimal curl. Size Size shall be a 3” x 5.25” or client’s choice with four rounded corners and a special die cut for easy application, to hang from rearview mirror.