Specifications include, but are not limited to: Rolled Paper –Form Size 18” x 11” (W x L)3.1.1.1Each roll must have minimum of 46,000 forms.3.1.1.2Each roll of forms must be smoothly spooled on a 6” core. 3.1.1.3Each 6” core must be flush with the sides of the paper roll.3.1.1.4Each roll must be thoroughly vacuumed to remove paper dust and chads.3.1.1.5Each roll must be clearly stamped with the direction of the unwind on the top and side of each roll.3.1.1.6Each roll diameter must be 47-50”.3.1.1.7Two (2) rolls must be packaged upright on a single pallet, both in the same unwind direction.3.1.1.8The rolls must be poly-wrapped together as one unit.3.1.1.9The rolls must not be openly exposed once they have been wrapped on the pallet.3.1.1.10Each pallet of 2 rolls must be double strapped through both roll cores and single strapped through the roll cores and looped across the top of the rolls.3.1.1.11Metal strapping material is prohibited.3.1.1.12Each pallet must be no largerthan 40” x 51”.3.1.1.13A moisture barrier must be present between the pallet and the bottom of the rolls, preferably a flat sheet of poly-wrap.3.1.1.14The poly-wrap must encompass the sides, top and bottom to form a complete moisture barrier.3.1.1.15Form must include 0.5” on each side with pin feed holes.3.1.1.16Form must have horizontal smooth edge perforation every 11”.3.1.1.17Horizontal perforations must be 8 to10 edge tied perforationsbetween pages with tensile strength of 4 to 14 pounds per linear inch.3.1.1.18Form must be blank stock, minimum 84 bright, #4 grade.3.1.1.19Form must not have any vertical perforations.3.1.1.20Form must not have any mill or roll splices.3.1.1.21Form must be 1-ply roll paper with 80% minimum chemical wood pulp, with no ground wood.3.1.1.22Form must be 20 pound paper.3.1.1.23Form must have moisture content of 3.7% to 5.3%