A. Using provided artwork from BFT, the Contractor will produce/print vehicle wraps to accommodate specifications of the vehicles dedicated to wrap. B. The Contractor will be responsible for measuring vehicles and checking artwork scale to the scale of the vehicle based on actual measurements of the vehicle being wrapped. C. The Contractor will be responsible to verify the vehicle measurements are accurate prior to production of the wrap (e.g. the Contractor shall measure the vehicle for proper fit for the wrap and make any adjustments needed to the Artwork to have it properly fit the vehicle. The Contractor shall consult with the BFT Marketing Department if any adjustments/changes are needed prior to production to get the BFT Marketing Departments written approval on such changes). D. The Contractor must provide a digital proof to BFT Marketing Department prior to production of any order so that BFT can verify and approve proof. The Contractor must receive written approval from BFT Marketing Department on the proof sample. If the ordered wraps received deviates from the approved proof sample, then BFT reserves the right to reject the wrap order and require the Contractor, at the Contractor’s expense, to replace the wraps. E. The Contractor shall provide vehicle vinyl wraps with the substrate material of 3M vinyl with UV laminate or an approved equal and installed according to or exceeding manufacturer’s specifications. F. Any material extended over the windows must be transparent from the inside, allowing drivers and passengers to see out. G. Prior to proceeding with the initial wrap installation, the Contractor shall meet or discuss with the BFT Marketing representative to review the vehicle to be wrapped and received any guidance instruction on the wrap layout.
