The general services listed below shall apply to the systems and equipment as shown on the Equipment List and as described in the section entitled Equipment Covered. ▪ Examine each piece of equipment and device to see that it is functioning properly and is in good operational condition. ▪ Clean all components of dust, old lubricants, etc. to allow the equipment to function as designed. ▪ Paint all equipment as needed to prevent and protect against corrosion and deterioration. ▪ Lubricate all equipment where needed to permit bearings, gears, and all contact wearing points to operate freely and without undue wear. ▪ Adjust all linkages, motors, drives, etc. that have drifted from the initial design settings and positions. ▪ Calibrate all sensing, monitoring, output, safety, and read-out devices for proper ranges, settings, and optimum efficiencies. ▪ Provide regular, on-site test of the general indoor air quality throughout the facility. Data collected should be used for proactive indoor air quality adjustments. ▪ Clean interior of system(s) ductwork. ▪ Provide detailed site mapping that outline equipment and operating controller locations, and unique unit identification numbers...
