Specifications include, but are not limited to: 3.1 EXAMINATION A. Examine areas where telescoping stands are to be installed, with Installer present, for compliance with requirements for installation tolerances and other conditions affecting performance of the Work. B. Proceed with installation only after unsatisfactory conditions have been corrected. 3.2 INSTALLATION A. Install telescoping stands to comply with referenced safety standard and manufacturer's written instructions. 3.3 FIELD QUALITY CONTROL A. Inspections: 1. Installation: Installation of telescoping stands shall be inspected for compliance with approved shop drawings by the owner’s on site representative for safety prior to use. 3.4 ADJUSTING AND CLEANING A. On completion of installation, lubricate, test, and adjust each telescoping stand unit so that it operates according to manufacturer's written operating instructions. B. Clean installed telescoping stands on exposed and semiexposed surfaces. Touch up shopapplied finishes or replace components as required to restore damaged or soiled areas. 3.5 DEMONSTRATION A. Engage a factory-authorized service representative to train Owner's maintenance personnel to adjust, operate, and maintain telescoping stands.