Specifications include, but are not limited to: A. Building Lighting – Lights and lamps in building are to be cutoff before contractor staff leaves the building. B. Clean and Sanitize - Surfaces are clean and sanitized when a disinfectant solution has been used to leave them free of all deposits, stains, film, and odor. C. Dispenser Refilling - Toilet tissue, toilet seat covers, paper towels, feminine hygiene products, and soap dispensers should be refilled whenever they are found to be less than half filled. D. Dusting - A properly dusted surface is free of all dust and dust streaks, lint and cobwebs. E. Floor Finishing - After machine scrubbing or stripping, apply two coats of sealer evenly to restore a hard, stain resistant finish. F. Glass Cleaning - Glass is clean when all accessible glass surfaces are without streaks, film deposits, stains, and finger prints. It has a uniformly bright appearance and adjacent surfaces have been wiped clean. G. Ground Litter Policing - The removal of trash and organic waste from the sidewalks and grounds areas immediately surrounding the Information Technology building. H. Light Fixture Cleaning - Light fixtures are clean when all components including bulbs and tubes are without insects, dirt, lint, film and streaks. All articles removed must be replaced immediately. I. Machine Scrubbing - Machine scrubbing is properly performed when all surfaces are without embedded dirt, cleaning solution, film, debris, stains, marks and standing water; and floor has a uniformly clean appearance. A plain water rinse must follow the scrubbing process. ; Restrooms (10) a. Check soap, toilet tissue, and towel dispensers daily and refill as needed b. Empty sanitary napkin receptacles c. Remove any trash and excessive soil from floors as needed. d. Thoroughly clean and sanitize all urinals and toilets, sinks, and soap dispensers e. Clean and sanitize all counter top surfaces f. Clean and sanitize baby changing table a. Clean all mirrors according to the glass cleaning standard g. Clean and polish stainless steel and chrome surfaces.