Specifications include, but are not limited to: . Flat roof replacement. (Areas to be replaced can be seen in Photo 1) a. Two areas, approximately 4,000 sq. ft. combined. b. The full tear off of the existing flat roof down to the concrete structural deck. c. Install a White, EPDM (50 mil or equivalent) roofing system with 5” Rigid Insulation. Installation must meet VA Code (USBC 2015), manufacture recommendations, and industry best practices & standards. 2. Re-shingling on sloped roof areas (Shingled area to be replaced can be seen in Photo 2) a. Approximately 3,000 sq. ft. b. The full tear off of existing shingles to plywood deck. c. Replace any rotten plywood. (This can be priced per sheet and determined as the need is found during the project.) d. Installed 30 year three tab shingles, including flashing as needed. Color to best match bell tower and other existing roofs. 3. Installation of water diversion cricket. (Cricket location can be seen in Photo 3) a. Construct, flash and shingle a cricket on the upper roof side of an existing brick chimney. Chimney is approximately 36” wide.