Specifications include, but are not limited to: Basketball Backstops i. Inspect and tighten all nuts and bolts. ii. Inspect the entire unit to make sure that no parts have slipped or moved from original installed position. iii. Visually inspect all cables and pulleys for wear and ensure free movement. iv. Lubricate all moving parts as recommended by the manufacturer. v. Check the goal for proper height and alignment with the floor key. vi. Check the backboard for proper level and alignment with the out of bounds line. ; Bleachers i. Check and tighten all fasteners. Replace all stripped, broken, missing or defective hardware. ii. Inspect wheel channels and reconnect if disengaged. Ensure all finger locks move freely and engage properly. iii. Check for deflecting deck and seat board support brackets. iv. Inspect all seat, skirt and deck boards for cracks, deflection or other damage. Inspect seat modules if so equipped for cracks or other defects. v. Inspect all welded connections and repair/ replace as necessary. vi. Verify wall blocking and anchors are secure and properly aligned. Adjust and repair as required. vii. Inspect and align all row locks and linkage assemblies. Replace any missing linkage pins or broken locks. viii. Inspect all intermediate deck support brackets for bends or cracked welds. Repair as necessary. ix. Verify all cross braces and secure any undamaged, repair and replace as required. x. Remove excessive lubricants and grease. Remove accumulated dust and debris from all moving parts, wheels, drives or tracks.