Specifications include, but are not limited to: 1. Contractor shall provide all materials, labor, tools equipment and supervisor necessary to remove existing 8’ fence at the pole shed and re-install per new layout, reusing existing fabric, rails, and fittings. 2. Swing gate at the entrance to be removed. New layout location will get a 14’ wide double swing gate with locking latches. Reuse part of the existing swing gate if possible. 3. Addition new fencing (approximately 105’ x 8’) to be installed across the back of the property behind the well house. 4. Contractor must verify all measurements. 5. Underground electric utility will be marked, Water and Sewer utilities will be estimated in their location. Hand digging in these areas of utilities is required. Contractor is responsible for any damage to utilities. 6. New materials should be the same quality as existing. 7. All non-reused materials must be new and in good condition. 8. All products must be installed to manufacturer’s instructions and specifications. 9. Clean areas and remove and dispose of any materials not reused ie: poles, concrete, etc.