General i. Swenson STCC model or Hydraulic Truck Conveyor (HTC) 1800 or approved equal ii Mountable on all standard dump bodies, VDOT dump bodies are approximately 95” wide, outside measurement iii. Mount to sides of truck dump body, allowing unit to remain parallel to ground, or easily lock into position for dumping over spreader iv. Receiving hopper: 1) Receive fill material from dump body 2) Belt conveyor extending transversely across rear of dump body, extend entire width of dump body v. Capacity, deliver granular material at 200 tons per hour, minimum vi. Mounting: 1) Folding legs 2) All necessary hardware for quick attach/detach mounting 3) Self-leveling at all positions of dump body vii. Removable from truck via quick disconnect pins Materials & Paint i. Carbon steel. ii. Powder coated, all metal parts iii. Powder coated parts: 1) Shot blasted to remove mill scale 2) Chemically cleaned in a high pressure wash / rinse system prior to powder coating iv. Color, manufacturer’s standard is acceptable provided the primary color is a shade of yellow or orange associated with construction equipment v. Powder resin to be electrostatically applied and properly cured Trough i. Trough endplates, 1/4" thick material, minimum ii. Feedgates: 1) Two each 2) Located at ends of trough 3) Rubber seals iii. Conveyor floor to be replaceable and bolted into position iv. Material, 11 gauge material minimum thickness, trough body, feedgates, and conveyor floor Conveyor i. Conveyor construction to be belt over chain type or c-section v-belt molded in center type ii. Belt, 18-inch wide, overall width including chains, (+1, -1), Rated minimum 350 degrees Fahrenheit iii. Belt conveyor, same length as truck width so fill material is dumped immediately adjacent to truck’s path (+6, -6) iv. Reversible, allow discharge of fill material to either side of truck v. Adjustable discharge and means to adjust belt tension, belt to track properly without need to readjust with varying density loads and when operating in either direction
