The School Board of the City of Hampton (HCS) is seeking bids to establish a contract(s) for door repair, door replacement, and door hardware supplies for interior and exterior doors on an on-call as needed basis. The contractor(s) shall provide all necessary labor, equipment, materials, hardware, and supplies to perform the work. Specifications The following specifications are not all-inclusive: 1. Flush Hollow Metal Doors: All metal doors shall be 1 ¾”, grade 3, 16 gauge and galvanized doors. Doors shall be fabricated with continuous rigid vertical reinforcing member, electrically welded to face sheets. Joints at vertical edges shall be continuously welded and finished. All doors shall be fabricated to fit existing frame opening sizes and sized to accommodate continuous hinged as specified. The use of filler plated for hinges and lock edges or face cutouts will not be accepted. Doors shall be primed painted. 2. Hinges: All doors shall be hung on continuous hinges unless specified otherwise. All continuous hinges shall be either half surface or full mortise type. Full surface hinges will not be acceptable. Where existing frame opening with sizes that do not vary more than 1/16”, half surface geared hinges must be utilized to allow for adjustment of the door in the existing frame so as to maintain the correct lock style clearance. 3. Panic Devices: Panic devices shall be restricted to Von Duprin 99 series rim panic devices. No substitutes allowed. All devices will be with pull handle trim and allen wrench (dog down). 4. Closer: Closer shall be restricted to LCN model 4040Xxp. 5. Lock Cylinder: Lock Cylinders must be able to accept Schlage IC core. 6. Door Hardware Installation: All door hardware shall be installed with through bolts or drilled and tapped into reinforcement plates. 7. Replacement Frames: All multiple door bank replacement frames shall be 14 gauge steel, fully welded and reinforced to accept door hardware. Frame face and depth dimensions shall be as specified in material list. Frames shall be primed painted. All single door replacement frames shall be 16 gauge hollow metal with sub frame 5 ¾” depth or better. 8. Exterior Doors: All exterior doors should be replaced with hollow metal doors. 9. Interior Doors: Masonite Sliced Red Oak Clear Finish, 1 ¾”, 5 ply, particle core, pre-machined for hardware. 10. Glass and Glazing: Lites shall be 3”X24” glazed with ¼” clear laminated or ¼” clear tempered in panted metal frame. 11. Finish: All hardware shall be number 626 satin finish unless otherwise specified. 12. The contractor(s) shall provide all necessary labor, equipment, materials, hardware, and supplies to perform the work
