Specifications include, but are not limited to: • UCA is in need of two omni-directional antennas (approximately 8’long) on the tower of the proposed site. RX antenna shall be at or around the 40ft mark and TX antenna shall be at or around the 30ft mark. We will need a TTA (tower top amplifier) installed at the RX antenna height with a coax jumper from TTA to RX antenna, one run of 7/8(AVA5-50) coax to the TX antenna and two 1/2” (LDF4-50A) coax runs to base of the TTA. All coax runs will be secured down the tower face using appropriate waveguide and coax cushions. Coax will be terminated at polyphaser inside the shelter. We will need 3 ground kits on each run of coax (top, base, entry port), weather seal all connectors using self-adhesive material and install entry boots at the entry port. Coaxes will need to be tested to ensure correct installation. UCA will provide the antenna mounts, antennas, ground kits, coax hangers, coax, and connectors. Any metallic hardware used outside and especially on the tower will be stainless steel, aluminum, or hot dipped galvanized steel (no electroplated type galvanizing, etc.)