Specifications include, but are not limited to: Manuals The bidder shall supply two operator and two service manuals with brine maker YES______________________ NO_______________________ Dimensions Maximum height 65” YES________________________NO________________________ Maximum length 120” YES NO_______________________ Maximum width 65” YES_________________________NO________________________ Brine Maker Storage/Holding Capacity Main tank must hold a minimum of 500 gal YES NO______________________ Hopper tank must hold a minimum of 500 gal Yes NO_____________________ Rock salt holding capacity must be a minimum of 3 cubic yards YES NO_____________________ Production Rate Minimum of 3,600 gallons per hour YES NO_________________________ Tanks and Plumbing Components of Brine Maker Tanks shall be constructed of stainless steel or UV treated polyethylene plastic YES NO______________________ All plumbing fittings shall be constructed of corrosion resistant material YES NO______________________ Primary pump shall be stainless steel centrifugal, coupled to single phase TEFC motor YES NO______________________ Secondary pump shall be stainless steel or epoxy coated cast iron effluent pump, including a ½ HP, 115V oil filled motor with thermal overload protection YES NO______________________ Two Vertical Storage Tanks Tanks shall be constructed of rotationally molded, UV treated, high-density linear polyethylene with minimum load capacity of 8,000 US gallons YES NO______________________ Top of tanks shall be equipped with an 18” threaded man-way for interior access YES NO______________________ Tanks shall have molded in lifting lugs YES NO______________________ There shall be two 2” 316 SS bolted fittings installed in the tanks, one fitting as close to the bottom as possible for draining and one fitting at the top of tank for filling YES NO_________________________ The bottom tank outlet shall be equipped with, stainless steel nipple, brass ball valve and male poly camlock fitting YES NO_________________________