All correspondence must be made through the Vendor Portal. Specifications include, but are not limited to: The contractor shall provide all labor, tools, equipment, machinery, and materials for the installation of the modular jail system. This project involves the installation of a modular jail system at the John A. Bell Adult Correctional Facility. It consists of the excavation of the sloped site for the construction of the foundation as well as the trenching of the existing 150-foot-long natural swale to a width of 2 feet. Best Management Practices will utilize a silt fence to retain the soil and mitigate the disturbance of the land. Extension of existing drainage pipes and roof drain approximately 20 feet and 50 feet respectively is required. Power must be extended from the electrical/maintenance building to the electrical manhole located southeast of proposed MJS. The water valve located between Building 64 and Building GH will provide water from the northeast of the proposed MJS. Firewater from behind Building GH will provide water for the proposed sprinkler system which must also be installed by the contractor. Plumbing and electrical conduit will also run underneath and be supported by the proposed MJS. Sewer line will run west of the MJS to the existing sewer manhole. Finally, a 40-foot-long fence is to be constructed on the west side of the MJS to enclose the modular unit. The installation of the fire alarm and security system will be the responsibility of the owner, Bureau of Corrections (BOC). The full set of manufacturer’s drawings will be provided after award.
