Specifications include, but are not limited to: Cold Equipment Tasks: • Temperature Calibration – Refrigerators should maintain an internal temp of 34 – 40 degrees F and Freezers should maintain zero to minus 10 degrees F • Operational – Check hinges, latches, seals, door and window heaters, evaporator unit, fan blades, covers, wiring fan rotation and bearing. • Ventilation – Check allowed efficient air flow and maximum thermal transfer. Cleaning air vents and openings shall be standard practice during preventative maintenance. • Insulation – Shall be inspected and checked for any leaks. • Drainage – Drains shall be inspected and checked for clogs or any other restrictions to maximize the operation of the cooling of the unit • Electrical – Voltage shall be verified and checked for any type of fire hazards or shorts. Hot Equipment Tasks: • Usability – Inspect all handles, knobs, etc. to verify they are functioning properly • Calibration – Inspect and verify cooking temperatures match the selection of the temperature dials • Efficiency – Check hinges, doors, seals, fasteners, kick plates to verify they are intact, tight and adjusted according to the manufactures’ specifications. Burners and pilots shall be cleaned to allow efficient air flow and allow maximum heat transfer. Flues shall be inspected for obstacles that decrease air flow to avoid excessive gas build up in work area. Ware Washing Equipment Tasks: • Calibration – Shall calibrate temperature, conveyor speed, final rinse pressure and sanitizer to manufacturers specifications for proper sanitizing of equipment • Drainage – Shall inspect drains to verify proper flow to prevent cross contamination • Pumps – Shall inspect and verify pump pressure is in accordance with manufactures’ specifications for proper operation/washing • Electrical – Inspect and verify voltage and check for fire hazards • Accessories – Shall inspect and verify all booster heaters and dryer blowers are functioning in accordance with manufactures’ specifications for proper operation/washing DELIME machine