Specifications include, but are not limited to: New truck Tailgate lift as follows: 1. To be mounted to an agency owned 2019 Ford F150 ½ ton Long-bed regular cab pickup truck 2. Reference: Tommy Gate, Thieman, Maxon or SAHA Approved Equal. 3. Quantity: One (1) 4. Platform: 2 Piece platform shall be approximately 57” (+/- 2”) wide by 36” deep (+/- 2”) with a minimum of 4” of taper to assist loading material and a minimum 36” of lift travel. Platform may be either steel or aluminum. 5. Lift Capacity: approximately 1,000 pounds capacity, minimum dual lift cylinders to insure an even and smooth lift. 6. Controls: Main controls to be mounted on the curbside of unit and equipped with a remote control pendant. Circuit breaker shall be 150 amps minimum. Controls to be sealed and weather proof. 7. Power: 12 volts DC electrically driven hydraulic pump. Motor and pump to be enclosed to prevent damage and have flow control valves to prevent overload/ overpressure to the hydraulics. 8. Access: Gate must be capable of being dropped without lowering to access the bed of the pickup. Shall provide access to the spare tire and its operating mechanism in its stock location. 9. Delivery: Vendor shall specify the time required to obtain and install the unit bid. Installation will occur at a mutually agreed to time between vendor and SAHA. 10. Warranty: Vendor must provide a 2-year warranty minimum parts and labor warranty or manufacturer’s standard whichever is greater. New Polyurea or Polyurethane Spray-in Bed Liner as follows: 1. To be installed in the above (1) 2019 Ford F150 2019 Ford F150 ½ ton Long-bed regular cab pickup truck and (1) 2018 Nissan Frontier ½ ton short-bed crew cab pickup truck 2. Reference: Rhino Solar-Max Liner or Line-X Premium liner or SAHA Approved Equal. 3. Quantity: Two (2) 4. Must be a hot, high pressure applied liner shall be free of runs and excessive build up. 5. Shall provide a skid resistant surface of consistent thickness. 6. Color shall be Black. 7. Bed shall be prepared for spray by mechanical sanding methods to insure good adhesion. 8. Delivery: Vendor shall specify the time required to obtain and install the liner into the specified unit. Installation will occur at a mutually agreed to time between vendor and SAHA. 9. Warranty: Manufacturer and Vendor must provide a lifetime warranty against delamination resistance to staining and chemicals, cracking, bubbling or peeling and labor to replace or repair.