Specifications include, but are not limited to: Provide and install an Open Options Part Number ENCL-2-L1 Teal 16 X 20 X 4 Enclosure with Tamper Switch, AQS1210B Power Supply & PDB-8C1R2 Power Distribution Board. Owner will provide the physical access control system (PACS) that will be installed in the enclosure. There will be five (5) controllers required (One controller for each control house door, one for the tamper switch, one for the main slide gate and one for the personnel gate (total of 5 controllers). (Each controller will be mounted in the Open Options enclosure). All of the controller boxes will then be mounted inside a single lockable enclosure with a tamper switch for the door. The enclosure will be mounted to a wall inside the control house. Provide a conduit sized large enough to house five Cat6 cables with tip connectors. The conduits will be attached to the top of the enclosure and run up the wall and over to the IT rack. Enclosure shall be grounded to the ground system in the control enclosure.
