Specifications include, but are not limited to: Engine John Deere 4045HFC04, 125 horsepower engine with NACD spring loaded clutch – Tier 4 FINAL (includes 5 year / 5,000 hour engine warranty) OR EQUAL. CHIPPER SPECIFICATIONS Unit shall have a 40” diameter x 2” thick (2 knife pocket) chipper disc, each pocket equipped with (2) ½” x 4 ½” x 7 ¼” dual edge knives. 360-degree HAND crank swivel discharge with 12” adjustable chip deflector and clean out and inspection door on discharge. Minimum 8,000-pound capacity tongue jack with 15” of travel and foot pad and 8,000-pound axle fenders and fender supports 12-volt system with rubber mounted LED taillights, 6 prong replaceable coiled power cord and protected heavy-duty wiring with junction box, and LED clearance lights with reflectors. Minimum 13-gallon steel hydraulic tank with magnetic drain plug, lockable filler cap, and sight gauge, also a minimum 40-gallon steel fuel tank with magnetic drain plug, locable filler cap, and aluminum sight gauge. Spring loaded slide box type feed system with (2) horizontal feed wheels minimum 10 5/8” diameter x 19 ½” wide. Also, (2) last chance safety pull cables. 29” high x 64” wide tapered infeed hopper with 30” fold down infeed hopper tray, heavy-duty taillight covers, and spring lift assists. (2) Radiator guard posts Safety control bar controls forward / neutral / reverse with an Engine disable plug for hood locking pin-preventing engine from operating without pin in place. Banded chipper belts and lockable aluminum toolbox. PAINT – Standard Imron Industrial Urethane Bandit Yellow.