Before starting the engine: A. Visual inspection - check the engine, radiator and generator for debris, foreign objects, loose or broken fittings, guards, and components. B. Cooling System – check for leaks, add coolant conditioner if required. C. Fuel System – Drain water and sediment from tank, Change fuel filters. (Included) D. Air Cleaner Element – Inspect; clean or replace. E. Governor- Check and maintain oil level. (Included) With Engine Running: A. Start the engine and check all gauges, oil pressure, fuel pressure, RPM (Frequency), generated voltage and engine jacket water temperature, for correct readings. B. Engine Crankcase – Check the oil level, maintain the oil level between the add and full marks on the engine running side of the dipstick. C. Radiator louvers – Check for proper operation. D. Leaks and noises – Check for leaks and unusual noises. E. Load Test – Load the engine to minimum of 30% of rated load. Operate at this level for minimum of 1.5 hours run time. F. Gauge Readings – After one hour of running record the readings of all gauges: oil pressure, fuel pressure, oil level, RPM (Frequency), generated voltage, service meters, engine jacket water temperature, exhaust temperature and manifold vacuum. After Stopping Engine: A. Adjust – Make any adjustments to the engine and generator set as necessary. B. Engine Crankcase – Change oil; take sample for analysis, change filters, cut old filter open and inspect for foreign material. C. Fuel level – Record the fuel tank level. D. Battery charge – Record the voltage. E. Automatic switches – Check that all switches are in proper position for automatic start.
