Specifications include, but are not limited to: This event is to bid for Installing a new fence and gate at the Army National Guard in Milan TN. Ornamental Security Fence Approved Model – Ameristar Impasse II – Gauntlet Style or approved equal - Install approximately 309 LF of 7’ tall security - Three-rail design - Line post to be on 8’ centers, all posts set in concrete, minimum embed 36” - Black “Perma-Coat” finish with 15-year warranty; Ornamental Security Gate - Approved Model – Ameristar Passport IS – Gauntlet Style or approved equal - Install (1) 24 LF cantilever 7’ tall security gate - Three-rail design - Black “Perma-Coat” finish with 15-year warranty; Access Controls – Furnish and install - Shall be compatible with existing AIPHONE system and tie in. - (1) dual height gooseneck-stand with two access control pads with cameras - Minimum 18” diameter concrete pad, embedded 24” in the ground, for gooseneck stand - install a (120v or 240v) single phase circuit, from the nearest service panel in the facility to the gate operator with 1” fiberglass/HDPE or PVC conduit with pull string - install 1” fiberglass/HDPE or PVC conduit for data communication from existing AIPHONE system to the access control pad/camera and operator with pull string - fully integrate the existing system with new components; test & verify proper operation of controls - (2) protective 6” steel pipe bollards, concrete filled, painted safety yellow, embedded 3’ in the ground in minimum 12’diameter hole with concrete. Shall extend 48” above grade and be plumb in all directions - Conduits shall be bored under any concrete or asphalt surfaces.
