Specifications include, but are not limited to: Wildlife Panel Specifications: • Dimensions, 194.5 inches long X 84.25 inches high. • Steel tubing 1 inches square, thickness 14 gauge. • Top corners of panel tubing are to be rounded. • Hinge pins constructed from 1/2 inch diameter steel rod. • The upper hinge pins are 5.75 inches long with 3.5 inches exposed below the strap and .25 inches above the strap for welding. • The lower hinge pins are 5 inches long with 2.75 inches exposed below the strap .25 inches above the strap for welding. • The bottom of the lower hinge pin strap is 18 inches above the bottom of the panel. • The bottom of the upper hinge pin straps is 71 inches above the bottom of the panel. • The bottom of the lower hinge loop is 15.5 inches above the bottom of the panel. • The bottom of the upper hinge loop is 68.75 inches above the bottom of the panel. • Hinges loops constructed from 2 inches X 1/8 inch steel strapping. • Panel to be made up of 4 horizontal tubes; one 8 inches above the ground, one at 59 inches above the ground, one at 71 inches above the ground, one at the top of the panel. • Standard galvanized cattle panel 16 foot X 50 inches X 4 gauge, welded to gate every 16 inches all the way around the entire panel. • Vertical spacers between the top 3 horizontal bars 63.5 (horizontal) inches from either side of the panel. Delivery: Panels will be pick up within the state of South Dakota by state agencies.