Specifications include, but are not limited to: a. Ride each car, check operation of car and hatch doors, acceleration, deceleration, floor stops and brake action. Make corrections as necessary. b. Inspect and wipe clean all motors, machines, gearboxes and generators using an approved solvent. c. Inspect controllers, selectors, selector drives and governors. d. Clean direction and accelerating switches. e. Inspect door monitoring equipment and safety edge units. Clean, lubricate, adjust or repair as necessary. f. Lubricate selector drive screws and guides and clean contacts if necessary. g. Check, repair and replace as necessary all floor enunciators and all other elevator signals (including bulbs) on the inside and outside of the elevator cars. h. Check car fan motors for proper operation. i. Inspect drive and secondary sheaves. Clean if required. j. Check bearings for proper operation and wear. k. Check machine gear oil. l. Examine, clean with proper solution, and repair as necessary commutator, brushes and brush holders of all small control motors and regulators. m. Thoroughly examine and clean starter and control panels. n. Examine and clean the buffers. Oil if necessary. Perform “hand test” of plunger return. o. Examine car and counterweight wire hoist ropes and governor for wear and condition. Re-rope if necessary. p. Clean car top and pit.