1. Contractor will provide all necessary electrical equipment between the pump control system and the well pump motor to ensure pump operates within the manufacturer’s guidelines. Anticipated flow range between 20GPM and 65GPM. Electricity will be made available by HCS at the location noted in Appendix A. A 7.5HP 230V Danfoss Variable Frequency Drive with Nema 12 Enclosure and pressure transducer (or HCS approved equivalent) shall be provided by contractor. 2. Well and pump system shall provide a minimum of 65GPM at a discharge pressure of 70PSI at the top of the well head. New pump to be installed on Certa-Lok drop pipe with bronze check valve above the pump end. The contractor must include all cable guards, safety rope, etc., as needed for a complete, professional installation. Finish well with center line of discharge tee 24” (inches) above finished grade. The Well is to be test pumped at 65GPM for a minimum of eight hours to ensure consistent water supply to the irrigation system. 3. Vendor will provide all necessary electrical equipment between the pump control system and the well pump motor to ensure pump operates within the manufacturer’s guidelines. Anticipated flow range between 20GPM and 65GPM. Electricity will be made available by HCS at the location noted in Appendix A. A 7.5HP 230V Danfoss Variable Frequency Drive with Nema 12 Enclosure and pressure transducer (or HCS approved equivalent) shall be provided by vendor. 4. The new well will be located at the Horry County School District Office as identified in Appendix A. Address at 335 Four Mile Road, Conway SC 29526 5. The new well must be relocated so the overhead power lines do not interfere with the future removal of the pump pipe.
