Specifications include, but are not limited to: • Gas Models - All spark plugs are to be adjusted and cleaned or replaced when necessary. • Diesel Models – All injectors will be inspected and or cleaned where applicable • Ignition condensers and points are to be adjusted, cleaned and/or replaced when needed • The entire system is to be kept lubricated and the oil changed, if the hour meter indicates more than 100 hours of operation since the last oil change. (Maximum number of oil changes per year is one (1). Change Filter annually. Record condition of oil level. Waste oil and filter will be removed from the site and included in the maintenance proposal cost. • Check hour meter to ensure that it is properly calibrated and operating properly and accurately and provide evidenced by a r e p o r t log. • Fuel tanks and lines are to be inspected for the purpose of determining if excessive sludge or rust is collecting. All fuel filters, sediment bowls etc. are to be cleaned and replaced when necessary. • Check the entire system for fuel, oil and/or water leaks • Check automatic transfer switch for proper operation and clean all contacts therein when necessary. • Check all instruments and/or gauges for proper operation. Adjust as required. • Check condition of ignition system • Check and record anti-freeze protection, condition and coolant level (add up to 1 gallon) Check low coolant level alarm • Check fuel and water separator • Check condition and tension of belts • Check and record exhaust system condition