Specifications include, but are not limited to:Hinged Metal PoleThe Hinged Metal Pole design shall be in accordance with the AASHTO Standard Specification of Structural Supports for Highway Signs, Luminaries and Traffic Signals and the following: COMPLY SPECIFICATION YES NO DEVIATIONS a. Shall withstand a wind velocity of 80 mph with maximum of 3 square feet area of attached equipment. b. Shall withstand a dead load of 100 lbs. at top of pole c. Shall support a side load of 100 lbs. 5 ft from base of pole d. Service life shall be greater than 20 years e. Fabricate from ASTM A572 high carbon steel. Provide a hot dipped galvanized finish. f. Fold-Over Assembly g. Secured Winch h. Pole base and access door with electrical grounding provisions for a No. 6 AWG conductor. i. 3”X5” Hand hole with cover, 4 feet from base of pole j. Two internal cable supports with hand-hole access. k. Internal cable guides that keep all cables clear of winch assembly and control the bend radius at hinge point. l. Lightning rod and mounting hardware. m. Ground Rod Kit n. Provisions for mounting a lightning rod bracket at three possible points on the pole. Each mounting is 90 degrees apart from the other beginning 90 degrees from cable exit. o. Cable exit portal near top of pole with cover plate
