Specifications include, but are not limited to:Contractor agrees to provide to the California Highway Patrol’s (CHP), Northern Division Area offices, including all detached out buildings the services described herein: furnish all supplies, materials, tools, equipment, labor, personnel, and supervision; pay all taxes, insurance, bonds, license and permit fees, and all other direct and indirect costs necessary to provide semi-annual roof maintenance and repair services in accordance with the terms set forth in this Agreement. A. Remove all debris from roof surface. B. Photograph and document any deficiencies on the Roof Inspection Checklist, Exhibit A-2. Immediately notify the CHP Facilities Coordinator of all deficiencies. C. Inspect interior of building for signs of water penetration, frost build-up, and structural distress. Onsite contact/designee will walk the facility with you. D. Inspect exterior of building for continuity of roof covering, deterioration of fascias, gutters, soffits, and performance of flashings. E. Remove accumulations of soil which may support plant life resulting in roof damage. F. Inspect condition of flat roof surface for blisters and ridges, splits or cracks in the membrane, open end or lap joints in the cap sheet or membrane, exposed felts or deterioration of any component of the roof system. G. Inspect all walk pads are in good quality, if not report immediately. H. Inspect for water ponding more than 72 hours after it rains which exceeds 1” in height. I. Inspect all flashings and/or gravel stops for deterioration, lateral tears or splits, and opening joints. J. Inspect any new penetrations from other trades such as, but not limited to, pipes, Air Conditioning (A/C) units, and satellite dishes. K. Inspect all flashings around equipment mounts, skylights, and roof top ventilators carefully for any signs of deterioration, foot punctures, or splitting in corners. L. Inspect A/C ductwork, skylights, smoke vents, vent stacks, pitch pans, to ensure they are sealed against water intrusion. M. Remove all debris from strainers over drain pipes, check seal between drain and roof membrane for any signs of drying or deterioration. Scupper will be opened to allow free drainage.
