a. Cab: Enclosed cab with A/C and Heat. Cab shall be pre-wired with installation of AM/FM radio, 12-volt power port and 40-channel CB, roof-mounted strobe light and factory backup camera. b. Operator Seating: Operator's seat shall be a suspension type with adjustments for height, weight, for/aft and suspension dampening with armrests and seat belt. c. Operating Weight: 39,500 lb minimum basic operating weight. d. Bucket: 8-yard minimum capacity trash bucket including a set of bolt on reversible cutting edges. 13 ft minimum dump height at hinge bucket hinge pin at full lift and 45-degree discharge, when equipped with a bolt on cutting edge. Maximum width is 144". e. Load Linkage: Standard Z-bar. f. Engine: 6-cylinder wet-sleeve cylinder liners Net Peak Power (230 hp) at 1700 RPM, 545 cu. in displacement. Machine capable of regeneration during full operation. g. Powertrain: Four speed transmission, axle coolers, heavy duty in board-mounted planetary, hydraulic inboard-mounted self-adjusting service brakes. h. Cooling System: Heavy-duty, Trash-resistant radiator and high-ambient cooling package, axle coolers. i. Steering System: Joystick steering (including conventional and adjustable steering wheel column) with gear shift, F-N-R and horn. j. Tires: 23.5/25/19.5 solid rubber k. Lighting: Front and rear work lights, brake lights, taillights. l. Electrical: 24 Volt to 12 Volt - 8 amp converter, 130 amp alternator, AM/FM/WB radio with CD player. 12 Volt Power Port. Remote jump-start access. m. Hydraulics: 2-Function hydraulic control with joystick, F-N-R switch, Automatic reversing hydraulic fan. n. Factory Installed Waste-Handler Package: i. Drive shaft guards to prevent debris from wrapping around the drive shaft and universal joints. ii. Axle seal guards to protect axle seals wheels from material wrapping around axle and seals. iii. Crankcase guard between rear counterweight and rear axle shall be hinged. iv. Hydraulic tank guard shall provide additional protection to front, sides and bottom of the tank. v. Fuel tank guard shall have protective platting on the front, bottom and sides. vi. Headlight guards of wire mesh to protect headlight lenses. vii. Steering cylinder guards to provide protection for steering cylinders and hydraulic lines. viii. Hinged power train guard protects the transmission and engine compartments. ix. Steel front fenders. x. Exhaust insulation shall insulate the muffler, exhaust manifold, tubing, and turbo. xi. Transmission sight gauge guard shall protect oil level gauge from damage. xii. Harness guard shall protect the main wiring harness in the hitch area. o. Maintenance/Parts: Bidder must give the location for the nearest parts department, drop boxes, etc., and describe the current maintenance services available.
