Excavator Component of Machine: Engine: Diesel, net HP 177 with an off-level capacity (gradeability) of 100%. Hydraulic System: Maximum flow of 58 gal/min, 5220 psi under heavy lift. Swing System: Full hydraulic, 360 degrees, 9.6 RPM. Cab and Controls: Fully enclosed; air conditioner; heater; suspension seat with fore/aft, height and weight adjustments with wide armrests; AM/FM radio; monitor for pre-start fluid levels and maintenance reminder; and safety glass (call). Cab Glass: Polycarbonate type glass just in the front windshield. Stick, Boom & Bucket: Boom length 33’ 6”, arm length 25’ 9”, bucket digging force minimum 17,000 lbs., maximum digging depth 47’ 11”, and maximum reach at ground level 59’ 7”. Bucket to be standard 60” clean out. Minimum Service Fill Capacities: Fuel capacity not less than 750 gal (Amphibious Excavator manufacturer to replace counter weight with fuel tank); cooling system not less than 5.4 gal; swing drive no less than 2.2 gal.; hydraulic system including tank not less than 79 gal; hydraulic tank not less than 38 gal. Note: The total weight of the fuel cell should be approximately 7,000 lbs. The tank with baffles would be fabricated with ½” metal and mounted and secured to the rear of the excavator in the location of the counter weight was removed. Undercarriage Component of Machine: Pontoons: 32’ x 6’ x 5’– Corten or Carbon steel material – four bulkheads each pontoon forming five water tight compartments – belly pan to conceal hose and swivel assembly – sandblast, dimetcote paint system – tank liner inside pontoon to prevent corrosion – 3/16” thick sides & top – ¼” thick bottom...
