Shawnee County is soliciting sealed bids for two (2) New/unused 2026 Trucks and 25-yard high compaction rear loader bodies per the following minimum specifications. INFORMATION TRUCK CHASSIS WARRANTY: 5 yr. bumper to bumper and 5 yr-200,000 mile engine (Cummins PP1) including engine after treatment and 5 yr. transmission. to include all parts, labor, on transmission, rear axles, any internally lubricated parts of diesel engine and including starter, alternator, fuel pump, fuel injectors, turbocharger, water pump, all engine electronics including chassis wiring to and from engine and transmission, modules, relays, solenoid, sensors, chassis wiring, switches, dash gauges, hvac, etc. With Towing. Must be included in the price of the truck. ENGINE: The engine shall be diesel fueled wet sleeve design with a minimum of 10 liters at 380 - 400 hp, turbo exhaust brake controlled from a dash mounted switch. The engine shall have a low oil pressure and high engine temperature engine shut down system. The engine must use an S.C.R. system to achieve compliance with E.P.A. 2026 emission standards. The fan will have a Horton two speed air operated clutch. The DEF tank shall be 9.5 gallons minimum of usable volume, located on LH side under cab. Exhaust must SHAWNEE COUNTY REQUEST FOR PROPOSAL (RFP) Page 2 of 16 be RH under cab DPF/SCR w RH SOC vertical tailpipe. Shall have Cummins 18.7 CFM ISL air compressor. Shall have engine mounted Power core air cleaner w/constant torque SS clamps, pop-up air flow restriction indicator. Shall have immersion engine block heater 120V 1000W. Shall have multi-function engine connector for body builder; body builder harness to EOF for customer installed remote throttle control. Shall have 160 amp alternator; fuel cooler required; must have heated filter/water separator w/WIF sensor. Starter shall be 12V electrical system w/centralized power distribution. Batteries shall be 3 Optima 31A Threaded post (950) 2,850 CCA. Must have battery disconnect switch on the side or back of the battery box to kill all power. Battery box shall be cantilever steel BOC w/fiberglass cover, mounted on LH side. Shall have jump start terminals mounted to the battery box. WEIGHT: The unit shall have a total GCW of no less than 62,000 pounds. WHEELBASE: The unit shall have a minimum wheelbase of 224”; CA shall have a minimum of 157”; and overall length shall be 376”. Turning radius of not more than 35 feet, TURNING RADIUS MUST BE STATED IN BID RESPONSE. AXLES AND SPRINGS: The unit must have an 16,000 K wide track steering axle, or approved equivalent. The front springs must have a capacity of not less than 16K with shock absorbers, 2-leaf, with threaded bushings for taper leaf springs. The unit must have a 46K rated rear axle rated at not less than 46,000 pound capacity, with 16 MM load housing & wheel to wheel differential lockouts in both rear axles, or approved equivalent. Gear ratio shall be 5.63. The rear suspension shall be Tandem Hendrickson HMX EX 460 46K, have 54” axle spacing with a laden height of 11.5 inches, with shocks, rubber bolster bushings, heavy duty (Hendrickson) torque rods, and Transverse track rods, or approved equivalent
