10.3.1.1 GENERAL 1. Visual Inspection - Visual inspection of overall condition of unit(s) to identify foreign objects, loose or broken fittings, guards, and components. 2. Wipe off unit(s) - Clean oil, coolant, fuel and acid deposits. (Police generatorarea.) 10.3.1.2 COOLING SYSTEM 1. Radiator/Heat Exchanger - Visual inspection for leaks, damage, and debris. Louvers operatecorrectly. 2. Coolant - Visual inspection for correct level and condition of coolant (rust, oil, and contaminants). Check coolant conditioner concentration and temperature protection. Check filler cap gasket and sealingsurface. 3. Hoses and Connections - Visual inspection of all hoses for deterioration. Check tightness of connections. 4. Fan Drive Pulley and Fan - Check for loose or worn pulleys and lube fan drive bearing. Check fan operation and clearance. 5. Fan Belts - Inspect for wear or deterioration. Check tension and adjust asnecessary. 6. Jacket Water Heater - Inspect for proper operation. Check thermostat settings for proper coolant temperature. 7. Water Pump - Visual and operational inspection for leaks or unusual noises. 10.3.1.3 FUEL SYSTEM 1. Fuel Tank - Visually inspect fuel tank system for leaks and fuel level. Test day tank pump for proper operation. Inspect fuel condition for contaminants (Color Kut). 2. Water Trap/Separator - Drain water from fuel tank or water separator whenpossible. 3. Fuel Lines and Connections - Inspect for leaks and tightness of connections. Check linebrackets. 4. Governor and Controls - Inspect governor oil level. Inspect controls and linkage for proper operation. Add oil as necessary. 5. Fuel Filters (Primary/Secondary) - Inspect for damage, leaks and proper operation. 6. Fuel Pressure - Operational check of gauge and correct pressure. 10.3.1.4 AIR INDUCTION AND EXHAUST SYSTEM 1. Air Filter Service Indicator - Note reading. Inspect for proper operation. Resetindicator. 2. Air Filter - Inspect. Clean as necessary. 3. Air Inlet System - Inspect piping and air filter housing for damage, loose connections, and evidence of leaks. Clean air filter housing if air filter is cleaned or replaced. Check housing seals andgaskets. 4. Turbocharger - Inspect for oil leakage or exhaust leakage. Check for unusual noises and properoperation. 5. Exhaust Manifold - Inspect for damage, loose or missing hardware, evidence of exhaust leakage. Inspect for oil slobbering. Load bank recommendation. 6. Exhaust System - Inspect silencer and piping for damage, corrosion, or leakage. Check rain cap. Check supports for vibration damage and loose connections.
