Service Provider shall provide all labor, tools, and equipment necessary to remove, replace, and vulcanize the new belt for the existing screw press conveyor, and remove and replace head and tail belt pulleys, shafts, block bearings, bushings, idlers, and associated hardware. The City will provide the conveyor belt and specified mechanical components. Service Provider shall be responsible for supplying any additional parts, materials, or products necessary to complete the work that are not explicitly provided by the City. The conveyor unit is located at the Hill Canyon Treatment Plant (9600 Santa Rosa Road, Camarillo, CA 93012). Services shall include, but are not limited to, the following tasks: REMOVAL AND PREPARATION A. Inspect and prepare the work area to ensure proper installation conditions and safe working environment. B. Coordinate with City staff on the application of Lockout/Tagout (LOTO) procedures and isolate/barricade the area using caution tape and/or safety cones. C. Coordinate with City staff and remove the existing conveyor covers, gearbox-motor unit, tensioners, and adjust the take-up mechanism as needed. D. City staff will disconnect the electrical motor and belt motion detector, if necessary. MECHANICAL PARTS INSTALLATION A. Install City-supplied mechanical components, including but not limited to: 1. Head and tail pulleys (2 units) 2. Head and tail bushings (2 each) 3. Block bearings (4 each) 4. Idlers, return, 24-inch CEMA C, 4-inch diameter, rubber cushion (7 units) 5. Idler brackets (14 each) 6. RB 2-7/16 SS303 TG&P stainless steel shaft (1 each) 7. RB 1-15/16 CRS 1045 TG&P tail shaft (1 each) 8. Miscellaneous hardware B. Service Provider shall be responsible for furnishing any incidental materials or components not specifically provided by the City that may be required to complete the installation. C. Reinstall gearbox-motor unit, brackets, and tensioners.
