A. Sweep behind driver’s seat. Remove any debris and clean under seat. B. Sweep the rest of the bus or van thoroughly, making sure to remove all debris under and between the seats. Ensure that the rear wheel wells are completely clean on each side, sweeping out any debris. (Take care to not sweep any debris into the bus or van lifts whether open or closed) C. Wipe the dash, driver’s gauges and driver’s sun visor (if equipped). D. Mop the bus floor thoroughly and scrub out any stains. Clean the steel runner on both sides of the floor. Mop thoroughly behind each wheel well and along the surface of the lower panel just below the seats. E. Mop the entire bus including the driver area floor. F. Remove any graffiti and/or gum. G. Clean and mop the flooring ledge at the rear of the entrance step well. H. After 4-5 buses have been cleaned, mop water is to be changed. I. All debris and trash is to be kept in a trash receptacle and disposed of in trash dumpster. J. Clean window frames and panels between and above each window. K. Clean each interior mirror used by the driver (includes mirrors at exit doors). L. Clean hand rails, equipment boxes and the fare box with a damp or dry cloth. M. Clean the entrance and exit door, including grab rails, step well lights and modesty panels. N. Clean all interior windows, speaker panels, A/C return air grill, ceiling panels, roof hatches and rear wall, including the area below the rear seats. O. Clean melamine panels above the windows to the bottom of the seat edge. P. Clean and disinfect surfaces frequently touched. Q. All cleaning material, i.e. mops and other equipment are to be provided by bidder.
