Servohydraulic Floor-Standing Test Frame (Actuator Force Rating = 100kN, Load Cell Capacity = 100kN, Actuator Stroke Length = 150mm, Close-coupled Hydraulic Service Manifold (114Ipm), Integrated Hydraulic Grip Supply up to 21MPa, handset for system operation included is preferred) Hydraulic Power Unit (Flow rate 26.5Igm at 21MPa, Power frequency= 60Hz, Voltage (3 phase)- 480V) Controller (Voltage :100-120V (AC) High Temperature Furnace (Maximum Achievable Temperature =1000°C, 2 zone furnace with the following hot zone dimensions: 50mm x 50mm x 50mm). Should include a temperature controller, Type K thermocouple connector kit for temperature monitoring. Hydraulic Wedge Grip Set used for tensile and fatigue testing (Static and Dynamic Maximum Force Capacity = 100kN or higher, rated for temperatures up to at least 175°C) High Temperature Grip Set used for high temperature tensile-compressive testing and fatigue testing (rated for temperatures up to 1000°C, dynamic force up to 68kN at 700°C, water cooled, mounting (threaded, M27 x 2mm), hydraulic pressure rating up to 13MPa) Grip Interface (rated for temperatures up to 1000°C, Buttonhead with shank diameter of 12.7mm) Hand pump for cooling of high temperature grips Wedge Sets Flat with Surfalloy wedge surface finish (rated for temperatures up to at least 175°C, rated for force loads of 100kN, able to hold a flat specimen with maximum thickness = 7.6mm) Round with Surfalloy wedge surface finish (rated for temperatures up to at least 175°C, rated for force loads of 100kN, able to hold a round specimen with maximum diameter = 12.7mm) Extensometers Axial extensometer (gage length = 25.4mm, knife edges for use with flat and round specimens, rated for temperatures up to at least 175°C, strain range rating of +20% to -10%) High temperature axial extensometer (gage length = 25.4mm, V chisel rods for round specimens, rated up to minimum temperature of 1000°C or higher, strain range rating of +10% to -5%) Include Software for System Operation, Calibration, Installation, and Training
