A. One (1), 13,400 lb. – 18,000 lb. GVWR Truck with Standard Cab, 108” Flatbed Body with Stake Sides and Auxiliary Lighting. RQS-DPR-2500121, M4 2024-360 1. Model: New, Current Production Year or Later. 2. Cab: Standard Cab, 2WD, DRW. 3. GVWR: As required to meet the payload capacity specified. 4. Payload Capacity: Minimum 9,800 lb. 5. Engine: Minimum 7.0 Liter Displacement; Gas or flex fuel. 6. Flatbed Body: 108” Flatbed Body constructed of 10 gauge smooth steel. Shall include 3 interlocking removable stake sides per side. All lighting shall meet Federal Motor Vehicle Safety Standards. Tail lights, backup lights, clearance lights and reflectors are required. LED if available from the manufacturer. Stop, tail, turn and backup lights shall be flush mounted with shockproof rubber grommets. A license plate bracket with light and wiring harness shall be provided. All wiring is to run in protective automotive split loom, securely mounted. Dimensions: Length: 108” Width: 96” maximum (without mirrors) Headboard: Full width 10 gauge smooth steel, approximately the height of the cab to match sides, with manufacturer’s standard rear view portals Sides: Three (3) interlocking removable 36”W sections on each side. Height approximately 40” and not to exceed cab roofline by more than 2”, steel channel upright stakes and wooden or manufacturer’s composite material slats, three (3) each per section approximately 10” height with 5” gap between slats. 7. Seating: Manufacturer’s Standard Vinyl Bench/Spit seat with three (3) designated seating positions. 8. Transmission: Manufacturer’s 4-speed automatic transmission with overdrive. 4.30:1 differential ratio or manufacturer’s closest ratio. LS or manufacturer’s equivalent if available. 9. Exhaust Emission Control System: Compliant with Federal Environmental Protection Agency (EPA) emission control standards. 10. Brakes: Manufacturer’s standard with Anti-Lock Brake System. 11. Steering: Hydraulic integral power. 12. Reverse Alarm: White Noise Reverse Alarm: Brigade SA-BBS-107 - Selfadjusting heavy-duty - 87-107 Decibels or approved substitute to operate with back-up lights. 13. Auxiliary Lighting: Body Lighting: Furnish and install four (4) remote flashing warning lightheads, Whelen Model TLIA or approved substitute, one each forward facing in the left and right front grill area and one each rear facing in the left and right rear body panel. Shall include clearly labeled cab mounted lighted switch. Contractor shall receive approval from the City’s Officer in Charge or designee prior to final installation of the lighthead switch. 14. Running Boards: Manufacturer’s Standard, full length as applicable. 15. Towing Provisions: Manufacturer’s Maximum capacity tow package including Engine and Transmission Oil Coolers if required by the manufacturer. Furnish and install Class IV hitch receiver bolted to frame; two (2) “D”-rings (one on each side of hitch receiver or manufacturer’s equivalent); single piece 12,000 lb. capacity combination pintle/ball hitch with 2” diameter ball; tube adapter (if required); pin and lock; three (3) keys or manufacturer’s equivalent. The vehicle shall be equipped with 7 blade receptacle wiring harness, as specified in Attachment A.
