1. Traffic signal - 12“ Aluminum 3-section, yellow body with black face doors and black cut away tunnel visors. Each 3-section signal must include a minimum of a 5-position terminal block (dual position, i.e., two screws per section and fully insulated) with mounting tabs. Terminal Block must accept a minimum of a number 8 Philips screw head. Terminal block should include quick push on tabs. Signals should be LED ready with mounting tabs for the LED’s. No reflectors or lenses needed. All hardware must be stainless steel. Hood mounting tabs will be of the 4-screw style. Slotted tabs are not acceptable. Doors must be equipped with 2 latches per section. Signals must meet or exceed ITE – required wind loading on a single point attachment. If there is a minimum order quantity, please indicate on pricing page. 2. Traffic signal 12“ poly carbonate 3-section, yellow body with black face doors and black cut away tunnel visors. Each 3-section signal must include a minimum of a 5-position terminal block (dual position, i.e., two screws per section and fully insulated) with mounting tabs. Terminal Block must accept a minimum of a number 8 Philips screw head. Terminal block should include quick push on tabs. Signals should be LED-ready with mounting tabs for the LEDs. No reflectors or lenses needed. All hardware must be stainless steel. Hood mounting tabs will be of the 4-screw style. Slotted tabs are not acceptable. Doors must be equipped with two (2) latches per section. Signals must meet or exceed ITE – required wind loading on a single point attachment. If there is a minimum order quantity, please indicate on pricing page. 3. Traffic Signal 8” poly carbonate 3-section, yellow body with black face doors and black cut away tunnel visors. Each 3-section signal must include a minimum of a 5-position terminal block (dual position, i.e., two screws per section and fully insulated) with mounting tabs. Terminal Block must accept a minimum of a number 8 Philips screw head. Terminal block should include quick push on tabs. Signals should be LED ready with mounting tabs for the LED’s. No reflectors or lenses needed. All hardware must be stainless steel. Hood mounting tabs will be of the 4-screw style. Slotted tabs are not acceptable. Doors must be equipped with 2 latches per section. Signals must meet or exceed ITE – required wind loading on a single point attachment. If there is a minimum order quantity, please indicate on pricing page. 4. Hoods, 12” for signals, Poly carbonate 4 mounting tab design. 5. Hoods, 12” for signals, Aluminum, 4 mounting tab design.
