a) Line 1 - Aluminum Boat i) Examples: Elastec WorkBoat Inlander 22’ Boat, Workskiff Landing Craft Series Model 23’ x 8.5’, or TPWD approved equivalent. ii) Quantity: One (1) iii) Requirement: Boat must conform to 33CFR, Code of Federal Regulations (Part #183) iv) Hull Length: Approximately twenty-two feet (22’) to twenty-four feet (24’)(including motor guard sponsons) v) Width/Beam: Minimum: One hundred one inches (101”), Maximum: one hundred two inches (102”) vi) Sides: Minimum of thirty-two inches (32”), Maximum of thirty-six inches (36”) vii) Cargo Capacity: Minimum three thousand seven hundred pounds (3,700 lbs); minimum twenty inch (20”), maximum thirty inch (30”) freeboard viii) Construction: (1) Fully welded marine grade 5052, three-sixteenth of an inch (3/16”) aluminum (2) Fully welded sides/beaching plate/bottom/transom (3) Console, Pilot Seat and Storage Areas (4) Cleats, Rails, Bow Storage, Non-skid deck tape, Bow and Stem Rubber Bumpers (5) Bow and Stem Davit Receivers (6) Stern Tow Post Receiver (7) Horn & Bilge pump (8) Aluminum deck/internal structure/wheelhouse 0.190 inch (9) Closed cell floatation foam (10) Hardware fasteners/door & hatch hardware - 316 Stainless Steel (11) Operation labels. ix) Electrical System: 12 Volt including Breaker Switch Panel x) Plugs: USB 12V and 12 Volt DC xi) Fuel type, Tank and Storage: (1) Fuel Type: Gasoline (2) Tank Capacity: Minimum eighteen gallons (18 gallons) (3) Fuel cell shall be American Boat and Yacht Council (ABYC) approved polyurethane with external fuel sending device with single drain line to bilge of the boat.
