1.2 Approval of Working Surfaces: Any contractor performing the work of other contractors shall notify the Architect of any unsatisfactory condition. Beginning of work by any contractor shall constitute the acceptance of the previous work. 1.3 Checking Dimensions at Site: Before ordering any materials or doing any work, verify all measurements of the building and be responsible for the correctness of them. No extras will be allowed for variations from drawings in existing conditions or for work performed under this contract. Any discrepancies found shall be submitted to the Architect for instruction before proceeding. The Section shall be enforced diligently. 1.4 Cutting & Patching: No excessive cutting will be permitted, nor shall any structural members be cut without the approval of the Architect. Each contractor shall leave all chases and openings straight, true and of the proper size in his work as may be necessary for the proper installation of his and/or other contractor's work. After such work has been installed, he shall carefully fit around, close up, repair, patch and point up same as directed, to the entire satisfaction of the Architect. 1.5 Cooperation: The General Contractor, all other contractors and all subcontractors shall coordinate their work with all adjacent work and shall cooperate with all other trades so as to facilitate the general progress of the work. Each trade shall afford all other trades every reasonable opportunity for installation of their work and storage of their materials. 1.6 Project Logbook: The project superintendent shall maintain a daily project logbook, indicating which subcontractors were on the job, time of arrival, and the number of workers. Statements as to the daily progress shall be logged. This logbook shall be made available to the Architect and shall be kept at the job site office. 1.7 Inspection and Tests: Architect and his representative shall at all times have access to the work whether it is in preparation or progress. Provide proper and safe facilities for such access and inspection. Make all inspections and tests in connection with this entire contract as required by the Architect. All material testing shall be paid for by the Testing Allowance and be done by an independent testing laboratory meeting the approval of the architect. 1.8 Security: Provide security fencing in all work areas. See Temporary Facilities. 1.9 Mockup Panel: Provide a mock-up for evaluation of product and application workmanship. 1. Install in area and of size designated by Architect. a. Construct mockup to illustrate backup wall, exterior sheathing, air barrier, cavity wall, connectors, weep holes, cavity vents, and through wall flashing. b. Construct mockup panel 72 inches by 72 inches to illustrate coursing, anchorage, mortar joints and color, window opening and flashing system. 2. Do not proceed with work until finish color, texture, pattern, joint sizes, and installation workmanship are approved by Architect. 3. Correct mock-up area as required to produce acceptable work.
