• Quantity: Two Hundred Twenty 4 (224) Stalls • Stalls must be new condition • Must be minimum of 10 foot x 10 foot • 10’ Color HDPE Portable Stall Fronts with Vertical Bars (indoor use) 224 pcs Sample Description: 1.25 frame 14 gauge cold rolled steel with full 1 inch tube set vertical 4” on center. Offset swing door with spring loaded plunger latch. ¼ inch HDPE sheet in lower half sandwich clamped in place, 2 ½” 12 GA solid flange around poly. All solid, welded frame Hot Dipped galvanized after Fabrication allow forklifting from top. Door Hinge on right, door to lay flat against next stall front when open, door to open 90 degrees when pushed into stall (lay flat against divider wall), Forklift hole in grill, index card holder welded to hinge side corner of door. 2 horizontal bucket tie 1” tube. Hot Dipped Galvanized. • 10' COLOR HDPE Vented Vertical Stalls 364 pcs Sample Description: - Vertical 10' BLACK Portable Vented Poly Stall Panel. 1.25 in X 1.25inch frame, 14 gauge cold rolled steel with ¼ inch HDPE sheet in lower half sandwich clamped in place. Hot Dip galvanized after fabrication. • Necessary hardware to connect stalls as configured below including, but not limited to, pins, starter poles, stall wall connectors, etc. • 25-year Rust free Warranty • Inserts shall be made of a high density polyethylene suitable for use with equine • Freight included for delivery to Extraco Events Center 4601 Bosque Blvd. Waco, TX 76710
