The scope of work includes the design and construction of approximately 23,000 sq.ft. / (100'x 230') pre-engineered steel Fleet Services Building with Service Bays and Fleet Department Offices as depicted in Appendix C, with related site work located at 0 Shannon Blvd., Nampa, Idaho 83703. The building will house the Nampa Fleet Services Department that provides automotive maintenance services to the City of Nampa vehicle fleet. The building shall be equipped with: • Approximately 23,000 sq.ft. / (100'W x 230'L x 24’Eave Height). Dimensionally 100' minimum width to accommodate a 75' tractor trailer combo to be pulled fully inside shop and have doors closed or as close as possible to identified exterior dimensions to meet engineering requirements, specific owner needs will be discussed during design • Parts room and office area access should resemble outlines in Appendix C as closely as possible • Approximately 4,000 sq.ft. office/parts room space • Parts room area to have roll up loading bay door o Loading bay door to be motorized with up/down controls on the interior adjacent to door o Parts loading bay door to be a minimum of 10’ x 10’ or as close as possible to meet engineering needs o Parts room area to have exterior “man-door” located as close as possible to loading bay door o Specific owner needs will be discussed during design • Approximately 19,000 sq.ft. shop area • Breakroom area to serve as dual purpose training area with full kitchen, cabinets, and cupboards. Full stove/oven is preferred, microwave, and sink at minimum
