WATER WELL TECHNICAL SPECIFICATIONS DRILLING RIG: A rotary type drilling rig shall be used to drill well. Rig must be of adequate size with the capability of drilling well to the required specifications. WELL LOCATION: Well to be drilled or plugged will be on land held in trust by the Commissioners of the Land Office (CLO). Contractor will work with the Supervising Real Estate Management Specialist (RMS) to determine the well site. RMS will ultimately be responsible for determining the well site. Contractor is responsible for recording the approximate locations for test holes and completed wells on a legible well log to be submitted to the CLO office. DRY OR TEST HOLES: Dry holes, or test holes, will be paid at the rate of (price bid for Test Holes) per foot. Limit of 2 test holes per location. Dry hole charge would only be paid in lieu of a completed water well being drilled. The test hole diameter and estimated depth for each test hole is to be determined by the contractor based upon well site geology and contractor's knowledge of the area. Supervising RMS must approve, in writing, test hole diameter, estimated depth and number oftest holes allowed for the site before test holes can be drilled. All dry holes and test holes must be properly plugged according to Oklahoma Water Resources Board (OWRB) specifications.
