The proposed is a turnkey project to update electrical components in existing shop building to include new breaker panel and breakers, lighting, plugs, and switches. Attached schematic provides building and room dimensions as well as where components are located. Power comes into the building as 3 phases but can be stepped down to single phase panel (drop high leg). Contractor may use existing conduits where present and retain identified (see schematic) plugs/switches if deemed up-to-code and more convenient and/or cost effective (see schematic, KP). Contractor is responsible for determining which components and wiring are up-to-code, safe, and sufficient for the intended use. The contractor will supply and install all components necessary for this project. Panel needs to be a minimum of 200Amp, 40 circuit. New components will include a total of fourteen (14) TS LED light fixtures (4 bulb), seven (7) outdoor overhead lights above doors, eighteen (18) duplex plugs, two (2) GFI switches, ten (10) switches, and metal conduit as needed. The Contractor is required to make site visit prior to submitting bid. All components must comply with the Federal Build American Buy America Act utilizing components built or manufactured in the United States
