Trailer 2.1. Frame: 2” x 2”, 11 gauge steel square tubing with mitered and full electric welded joints 2.2. Cross Members and Supports: 1/8" x 1-1/2" x 1-1/2" angle steel 2.3. Bed of Trailer: 5’ 8” x 8’, 10 gauge steel plate 2.4. 1,700 lbs. capacity 2.5. Two (2) 13 x 175-80-D tires 2.6. L.P. Bottle Support with holding clamp 2.7. 2” ball hitch 2.8. Corrosion resistant safety chains of adequate size and length 2.9. Swing-away crank-style jack mounted to trailer 2.10. Marker basket mounted to trailer bed near operator 2.11. Utility box mounted to trailer, 14 gauge steel, 23” x 32” x 12” Operator Seating 3.1.1. Two (2) fold down seats, one located on the left and one on the right side in front of trailer wheel 3.1.1.1. Complete with foot supports, guard rail and seat belts 3.1.1.2. Foot supports adjustable for leg length 3.1.1.3. The complete seat and foot frame with valve line, swivels to a vertical position and fastens in place by a pin and socket 3.1.2. The operator's seats are approximately 9" above ground 3.1.3. Operator safety containment bar welded to trailer bed Power Pack 4.1. Power Pack Frame 4.1.1. Constructed from 1/4" x 3" angle iron 4.1.2. Supported by 1" rubber pads off trailer bed 4.1.3. Generator, air compressor, engine and belt guard are all mounted to frame 4.1.4. Mounted to trailer 4.2. Generator 4.2.1. 4500 watts 120 VAC at 3600 RPM with voltage gauge 4.2.2. Electric power can be supplied from other source for pre-start
