1. Project Location and Goal The CPMD is seeking proposals from responsible, qualified and independent contractors to supply and install a permanent no-climb, perimeter fence around the Crownpoint Chapter Cemetery Site. The perimeter fence/wall will surround the 40.46± acre (5,568± linear feet) Crownpoint Chapter Cemetery Site tract. The 40.46± acres includes burial plots for civilian and veteran community members. The Chapter has the following objectives for this project: ● Define boundaries and channel access and egress; ● Provide visual barriers, supports security and safety; ● Deter and delay intrusion and trespassing; ● Provide security; ● Provide cost-effective method of protecting facilities; 2. Available / Existing Data The chapter has completed the pre-development services that are needed to facilitate the construction of the perimeter fence and is providing the following documents with the RFP: ● Attachment A – Legal Boundary Survey; ● Attachment B – Site Plan; 3. Project Technical Description Offeror(s) shall furnish all labor, material, and equipment to complete the work as outlined further in this section and as indicated on the Schedule Attachment E. Unless otherwise stated, all content outlined in this section should be considered as incidental to the schedule. A. Minimum Specifications for Perimeter Fence Length of Fence Perimeter shall be based on lengths as shown in Attachment A – Legal Boundary Survey a. Fence Fabric i. 6’ high x 11-1/2 gauge Galvanized Chain Link Fabric (2-1/4 x 11-1/2 x 72 GAW), KK, 50’ roll b. Framework i. 1-5/8” x 21’ Swedged End HF20 (0.085 wall) ii. 2” x 8’ Galvanized HF20 cut post (Line Post) iii. 4” x 12’ Galvanized HF40 cut post (Gate Post) iv. 2-1/2” x 8’ Galvanized HF20 cut post (Corner Post) c. Post Fittings i. Eye Top Loop Cap 2” x 1-5/8” – Pressed Steel ii. Post Cap 2-1/2” Aluminum Dome iii. Post Cap 4” Aluminum Dome iv. 2-1/2” Galvanized Beveled Brace Band – Round v. Rail End Cap 1-5/8” Brace Combo Pressed Steel vi. 3/16” x 5/8” wide x 72” long Tension Bar vii. Tension Band 2-1/2” Beveled 12-gauge x 7/8” viii. Carriage Bolt/Hex Nut 5/16” x 1-1/4” d. Wire and Ties i. Tie Wire 1-5/8” Aluminum Pig-Tail 9 gauge (6”) – Bag of 100 ii. Tie Wire 2” Aluminum Pig-Tail 9 gauge (6-1/2”) iii. 7-gauge Galvanized Spiral Tension Wire – 1000’ roll iv. 11-gauge Steel Hog Ring
