• The Contractor shall provide a proposal for the disposal of old system(s) and the furnishing and installation of a new cellular-enabled fire alarm system. This includes all associated equipment, devices, and hardware, such as but not limited to smoke detectors, horns, strobes, heat detectors, pull stations, key pads, fire alarm control panel(s) (FACP), transmitters, cellular communicators, back up batteries, wire, HVAC shutdown integration, cover plates, signage, and any other necessary components. • All the existing intrusion detection devices and components shall be removed and abandoned. Any areas where intrusion devices are removed shall be repaired, and have blank plates installed as required. • A sub-FACP shall be installed near the front entrance, preferably in the location of the existing intrusion keypad. • There are currently seven (7) strobes, fourteen (14) smoke detectors, two (2) keypads, four (4) pull stations, thirteen (13) motion detectors, and two (2) heat detector devices known of throughout the facility. • New equipment shall be installed in the same locations as existing equipment. • The Contractor may reuse existing wiring and pull stations only if the Contractor deems it in good standing condition. However, the Contractor shall absorb any cost if it is decided to keep said equipment and results in any defects effecting operation of new system.
