All correspondence must be made through the Vendor Portal. The Contractor shall convey the quality and condition of lubricants and equipment by reporting the results of the following tests. The following test suites list the minimum number of tests that shall be run and reported. PROCURED LUBRICANTS A General Lubricant Condition Report shall be provided for all tested procured lubricant samples. The report shall include, in addition to the test specified below for each Item, the following information, where applicable: FT-IR Analysis Particle count Crackle test Viscosity (cSt) Water (IND/KF) Oxidation Sulfates TAN (Total Acid Number) (for other than IC engines) TBN (Total Base Number) (for IC engines) Additives Contaminants ITEM 1: Procured Light Turbine Oils -ASTM D-92 Flash Point -ASTM D-97 Pour Point -ASTM D-445 Oil Bath - Kinematic Viscosity of Oil at 40ºC and 100ºC -ASTM D-1401 Demulsibility -ASTM D-2270 Viscosity Index -ASTM D-2272 Rotating Pressure Vessel Oxidation Test, min -ASTM D-892 Foam Sequence I, II, III ITEM 2: Procured Multi-purpose EP and Semi-synthetic Grease -ASTM D-92 Flash Point -ASTM D-217 Cone Penetration -ASTM D-2265 Dropping Point ITEM 3: Procured EP Compound Grease -ASTM D-92 Flash Point -ASTM D-97 Pour Point -ASTM D-445 Oil Bath - Kinematic Viscosity of Oil at 40ºC and 100ºC -ASTM D-2270 Viscosity Index
