The boats shall be fully assembled upon delivery or pickup. The boats shall conform to all federal, state, and marine safety regulations. The boats shall be constructed in accordance with or exceed industry standards for this type of vessel. Reconditioned or used parts will not be accepted. The boats shall be only constructed of fiberglass. The boats will be designated for year-round operation in marine environment. Safe operation is essential. Specific Vessel Specifications and Dimensions/Ratings LENGTH: 23’ to 25’ BEAM: 7’-8.5’ DRAFT: 12’-12.5” HULL TYPE: Hybrid Bay Hull HULL DEAD RISE: 15-16 Degrees WEIGHT (LOADED): 3,900-4500 LBS MAX. H.P: 300-350 H.P. FUEL CAP.: 75-85 Gallon HULL: Offshore (to 15 miles offshore capable hybrid bay hull) Hull shall be a minimum of 23 feet long and a maximum of 25 feet long, with a minimum of 84-inch beam. 10-year structural warranty General Deck/open floor one level with self-bailing cockpit 18-inch minimum spacing between console and gunwale 22-inch minimum spacing between the leaning post and rear seating Built in anchor/forward locker Console with windshield and compartment door Anchor locker with an internally mounted bow eye Large capacity bow storage minimum of 70 gallons Large bilge pump access hatch Hull constructed with vacuum-assisted resin infusion fiberglass with vinyl-ester skin coat suitable to provide above average strength, long-term durability, and fuel efficiency Hull made of entirely composite materials. No wood is to be used in the construction of the hull. All fasteners used in the construction must be 316 grade stainless steel and any fasteners penetrating the deck or hull must be sealed with marine grade adhesive/sealant. T-Top with electronics box mounted in frame, Hardtop with rod holders, spreader lights, anchor lights, and antenna Under gunwale folding rod racks Standard flush mount rod holders (minimum 2 per side) Heavy-duty stainless steel bow eye for attachment to trailer. (2x) stainless steel lifting eyes with backing plates on stem for towing and securing stern to trailer. Standard pop-up cleats (minimum 2 per side) Additional cleats midship and stern (2) Molded swim platform with three-step folding ladder Trim tabs with indicator light switch on console Leaning post seat with arms, flip-up footrest, rod holders (4), and storage capability Removable, insulated forward-facing seat at front of console INSTRUMENT CONSOLE Hydraulic steering system for 300-350 HP engine Manual Bilge Switch (in addition to hard wired float switch) with 2 bilge pumps Aerator live well switch Navigation light switch Interior courtesy LED lights Toggle switch panel for electronics Stainless steel cupholders measuring a minimum of 3.5 inches for accessibility of department issued handheld radios and cell phones Steering Wheel, stainless w/knob Tilt Steering Helm Marine Compass Weatherproof storage compartment built into top of console with friction hinges and compression latch able to store department-issued iPad, printer, and corresponding chargers.
