1. Barrel tile and underlayment removal– all existing barrel tile will be removed without causing any damage to the existing underlying roof structure (i.e. plywood decking, stacks, etc.); remove underlayment, drip edge (approximately 200 lf each building) and other roofing components (including flashing). 2. Dispose of all removed material consistent with federal, state and local laws and regulations; no debris is to be left on site at ground level or any area that residents may access at anytime. Contractor must supply their own dumpster. Use of dumpster on site is strictly prohibited. 3. Inspect and repair roof decking: check the underlying materials for any indication of rot, damage or other conditions that compromise the integrity of the roof. Replace up to 10% of the existing plywood decking at no additional cost to Miami-Dade County. If more than 10% of the underlying decking is unsuitable for re-use, contact Miami-Dade County project manager before proceeding. 4. Install underlayment consistent with all state and local regulations and manufacturer requirements or 30# felt and tin caps whichever is more stringent; 5. Install new flashing at all stacks and other roof penetrations; 6. Install drip edge; 7. Install new Architectural Dimensional shingles (shingles must comply with Miami-Dade County cool roof policy) consistent with state and local codes/regulations; contractor to provide submittals for review 8. Install venting if necessary for compliance with state and local codes/regulations; 9. Install flashing at all penetrations ensuring that it is properly sealed to prevent water penetration (with roofing cement or caulk); 10. It is the responsibility of the selected contractor to call for all required inspections and to make corrections as required